Humminbird Mega Live Imaging TargetLock gives you complete control over where you’re looking with your Mega Live Imaging Live Sonar!

TargetLock is made exclusively for Minn Kota Ultrex trolling motors with 45″ or 52″ shafts —- but don’t despair if you have an Ultrex with a 60″ shaft! Early reports from on-the-water users are that TargetLock works on 60″ shaft Ultrexes, as long as you bow is low enough to the water to keep the Mega Live Imaging Transducer in the water. Bow height and wave height will affect how well this works on your 60″ Ultrex motor!

LOCK ON! FISH ON!

Take aim with absolute confidence—and complete boat control. Unlike anything else on the water, Humminbird Mega Live Imaging TargetLock locks on to structure at the push of a button, even while your boat is moving or anchored using Minn Kota® Spot-Lock®. That means you’ll never again have to choose between MEGA Live Imaging and Spot-Lock, two of fishing’s most powerful technologies. And it’s only from Humminbird.

SEPARATE YOUR LIVE SONAR AND TROLLING MOTOR

No two technologies have done more to transform fishing than Humminbird MEGA Live Imaging and Minn Kota Spot-Lock. But only one of these difference-making features could be used at a given time. Not anymore. With the MEGA Live Imaging TargetLock accessory, the MEGA Live transducer beam can be steered independently of the trolling motor—from the foot pedal, the fish finder, or optional hand remote.

SET YOUR SIGHTS, THEN SET THE HOOK

Lock your MEGA Live view onto fish-holding structure, whether your boat is moving or anchored using Minn Kota Spot-Lock.

DIVIDE AND CONQUER

The TargetLock transducer can move independently of the trolling motor, meaning anglers can now easily view real-time sonar returns while steering in wind, waves and current.

MEGA LIVE SWEEP

Put your head on a swivel – Get an automatic, constantly updated, 120° view of structure and fish—no matter where your trolling motor is pointed.

MINN KOTA STEER

Launch a coordinated attack – Control both your trolling motor and the MEGA Live transducer at the same time using the foot pedal of your i-Pilot Link® Ultrex™.

ONE-BOAT NETWORK BUTTON

Make a powerful impression – This programmable softkey lets you activate MEGA Live Sweep Mode, activate Minn Kota Steer, or set a waypoint on your Humminbird® chart—with even more capabilities on the way.

THE PERFECT COMBINATION – MEGA LIVE TARGETLOCK +MEGA 360 IMAGING

Find your angle of attack using MEGA 360 Imaging, then lock it in with MEGA Live Imaging TargetLock. Both technologies can be run simultaneously with full functionality using the optional dual mount bracket on your Minn Kota® Ultrex™ Trolling motor.

GET TARGETLOCK ON YOUR BOAT TODAY!

Already have Mega Live? Go with the Humminbird Mega Live Target Lock Adapter Kit for Ultrex

Don’t have Mega Live yet? Go with the Humminbird Mega Live Target Lock With Mega Live Included

(0)

Built-In MEGA Side Imaging is now available on select Minn Kota Ultrex and Ulterra trolling motors.  This latest innovation from Minn Kota allows anglers to see the clearest, most precise images of structure and fish in real-time, both directly below and to either side of their boat!

MEGA Imaging® operates in the megahertz range, providing three times greater detail than traditional 455 kHz frequencies. Adding Humminbird’s MEGA Side Imaging to Minn Kota trolling motors through the built-in MSI transducer results in the clearest, sharpest real-time images, without the need to run wires which can clutter up the installation and compromise the use of the trolling motor.

With Built-In MEGA Side Imaging, the transducer is housed in the motor’s lower unit and the wiring runs through the indestructible composite shaft providing clean rigging that is protected from.  Having the transducer integrated into the trolling motor allows anglers to see what is directly below the bow and to the side of the boat rather than off the transom, meaning anglers can make better informed decisions in real time.

Ultrex and Ulterra trolling motors with the new Built-In MEGA Side Imaging transducer are also equipped with i-Pilot® Link™ and work in the “One Boat Network” system.

Trolling motors with the new MSI transducer are fully compatible with MEGA Imaging and MEGA Imaging+™ equipped Humminbird fish finders. Anglers fishing with a MEGA Imaging+ Humminbird unit will get 20 percent more detail compared to MEGA Imaging.

An MKR-MI-1 Mega Imaging Adapter Cable is needed to connect the built-in MSI transducer to Helix units.  No adapter cable is needed to connect the MSI Transducer to Solix units.

Minn Kota MSI TransducerMinn Kota Ultrex Mega Side Imaging Transducer

 

(0)

Minn Kota revealed trolling motors with their new Built In MEGA Down Imaging Transducer at the 2018 iCast Show.  The new trolling motors will be available in the Fall of 2018.

Models receiving the MEGA Down Imaging option (ie. MDI) include select Ultrex, Fortrex, UlterraTerrova With iPilot, and Terrova With iPilot LINK models.

Humminbird’s ultra-clear MEGA Imaging is the first down imaging technology to enter the megahertz range, with performance that’s nearly three times greater than traditional 455 kHz frequencies.  This results in the clearest, sharpest on-screen images ever seen!

The MEGA Down Imaging Transducer is housed in the indestructible lower unit motor housing.  The wiring runs through the composite shaft for a clean, protected installation.  No more external transducers! No more exposed wiring and clamps! Just an uncluttered look and protection from the elements!

The built-in MDI transducer also provides CHIRP Digital Sonar for precise, crystal-clear returns of fish, structure and the bottom.  Sweeping multiple frequencies across a broad spectrum, this powerful tool eliminates noise to show precisely defined targets.

Please Note:  The built-in MDI transducer provides MEGA DI and 2D CHIRP Digital Sonar to select Humminbird fish finder models.  You can only view MEGA Down Imaging with a MEGA DI or MEGA SI Helix G2N series unit (which requires the use of an adapter cable) or with any Solix G2 unit (no adapter cable required).  The built-in MDI transducer cannot supply MEGA Down Imaging to HB models that do not already have MEGA DI capability.  The built-in MDI transducer will supply 2D CHIRP Digital Sonar to G2 and G2N Helix units (even if they  are not MEGA DI capable).  MDI transducer is available only on Minn Kota models equipped at the factory and cannot be added to an existing motor.

Minn Kota Ultrex Mega Down ImagingMinn Kota Ultrex Mega Down Imaging Transducer

(0)